Council Dashboard
Welcome to our dedicated council support page.
Voltex
- Voltex is applied to footings, underslab, insitu walls & shotcrete walls
- Laps are fixed closed tightly (nailed or glued)
- Drain coil is kept a minimum 50-100mm off the membrane
If Voltex is terminated onto a concrete substrate:
- Is the horizontal termination bar fixed in position keeping a tight seal at the top
- If on an external wall, is Cetcoat applied showing 200mm min above termination bar
- Is sealant applied across the top of the termination bar to deflect water on external walls
- Are all penetrations detailed where passing through the membrane
- Types of acceptable protection: Allco Allguard, 3mm Corflute, Aquadrain, HD polystyrene
- If poured insitu no termination bar is required
Copyright © 2025 AllCo. All rights reserved. Website by Run Wild Studio.