Council Dashboard
Welcome to our dedicated council support page.
Swelltite
- Swelltite is applied to concrete or blockwork only
- Swelltite vertical laps are taped
- Horizontal lap is fixed closed tightly (nailed or taped)
- Drain coil is kept a minimum 50-100mm off the membrane
- Acceptable types of protection include: Allco Allguard, 3mm Corflute, Aquadrain, HD Polystyrene or 6mm Fibre Cement Board
If Swelltite is terminated:
- Is the horizontal/vertical termination bar fixed in position keeping a tight seal at the top
- If on an external wall, is Cetcoat applied showing 200mm min above termination bar
- Is sealant applied across the top of the termination bar to deflect water
- Are all penetrations detailed where passing through the membrane
Copyright © 2025 AllCo. All rights reserved. Website by Run Wild Studio.